8
• Mandatory
• Obligatorio
• Prohibition
• Prohibición
• Indication
• Indicación
• Warning Triangle
• Triángwulo De
Advertencia
These signs will give advice for your safety
Before leaving our factory every machine
is thoroughly tested.
Follow our instructions strictly and your machine
will give you long service in normal operating
conditions.
1. Features
See Operating Instructions / Parts
List Document
Nominal Weight: See “Specifications on this
document”
Operating Weight: See “Specifications on this
document”
Blade Shaft RPM: See “Specifications” See
“Specifications on this document”
Before starting up machine make sure you
read these instructions and the separate
OPERATING INSTRUCTIONS document
supplied with the unit, also make sure that
you are familiar with the operation of this
machine.
The working area must be completely clear,
well lit and all safety hazards removed (no
water or dangerous objects in the vicinity)
The operator must wear
protective clothing
appropriate to the work he
is doing.
We recommend hearing,
respiratory and eye
protection.
Any persons not involved in the work,
should leave the area.
Use only blades marked with a maximum
operating speed greater than the blade
shaft speed.
2. Assembly
PS1411S Electric Model:
♦ Assemble the PS1411S Model using the
instructions provided in the OPERATING
INSTRUCTIONS AND PARTS LIST document
supplied with this saw.
PS1411S Electric Model:
♦ The single phase masonry saw motor is furnished
with the correct NEMA configuration PLUG (OO)
on the motor pigtail. The matching connectors are
as follows:
Electric Motor Plugs & Connectors
Motor
Rating
Motor Pigtail
Plug
(NEMA No.)
Connector
Required
(NEMA No.)
1-1/2 HP
15A, 125V 5-15P 5-15R
IMPORTANT NOTE: The PS1411S model has a single
voltage ONLY motor. The motor CAN NOT be rewired
for 208-230 volts. Also the motor on this saw DOES
NOT have a voltage change switch mounted on the
terminal box like the PS1411 model.
WARNING: Always make sure the saw in
connected to a properly grounded electrical
outlet. Failure to comply with this warning
could result in serious bodily injury or
death!
WARNING: DO NOT operate on low voltage!
Low voltage causes loss of power, motor
overheating, and possibly motor winding
burnout. Voltage should be checked at the
motor while it is operating.
Good motor performance depends on proper voltage.
Extension cords that are too long and / or too small
reduce the voltage to a motor under load. Use
extension cords NO SMALLER than the sizes indicated
in the chart shown below:
EXTENSION CORD SIZE (Minimum)
MOTOR
50 ft Long 75 ft Long 100 ft Long
HP 120 V 230 V 120 V 230 V 120 V 230 V
1-1/2 # 12 N. A. # 10 N. A. # 10 N. A.
3. Check Before Operating
See Operating Instructions / Parts
List Document
All Models:
Electric Models Only:
