English
10
Cleanup
Start
When cleaning, use the appropriate cleaning solution (warm, soapy water
for latex materials; mineral spirits for oil-based materials)
IMPORTANT: Never clean nozzle or air holes in the spray gun with sharp
metal objects. Do not use solvents or lubricants containing silicone.
Special cleanup instructions for use with flammable solvents
(must have a flashpoint above 70ºF (21ºC):
Before you begin:
To clean:
1. Turn the turbine o (0).
Divide the spray gun. Push the Quick-Change
lever below the trigger (a), twist and separate
the front end from the handle.
Electrical contacts in gun handle and
hose. Never hold the gun handle and
hose under water or immerse it into
liquids.
2. Unscrew the container and remove.
Empty any remaining material back into the
material container.
Pre-clean the container and suction tube using
a brush and appropriate cleaning solution.
3. Clean the air vent (b) on the suction tube.
4. Pour a small amount of the appropriate
cleaning solution into the container. Attach
the container to the gun.
5. Connect front end assembly and gun handle.
6. Turn the turbine ON. Spray the cleaning
solution into a safe area.
Note: If you are spraying into a waste container as
shown, have the spray pattern width set to narrow
to better direct cleaning solution into the waste
container.
Repeat the above procedure until the solvent
or water emerging from the nozzle is clear.
Continued on next page
1
3
65
2
4
Empty waste
container
