A SERVICE OF

logo

2. Hardware Installation
English
2
2. Connect a CAT-5 RJ-45 network
cable from the computer to an
available Ethernet port of the
TEG-160WS/TEG-240WS.
1. Connect the Power Cord to the
rear of the TEG-160WS/
TEG-240WS and then to a power
outlet.
Note: After hardware installation is complete, use the Web-based Smart Utility
to configure the TEG-160WS/TEG-240WS. To access the Web-based Smart
Utility, open your web browser, and enter the default IP Address
and default password "admin". Make sure your computer
and the TEG-160WS/TEG-240WS are configured to the same network
segment.
http://192.168.0.1