23
2-1-7 Reset
2-2 WAN
The Broadband Router supports the following types of Internet
connections: Dynamic IP Address, Static IP Address, PPPoE, and PPTP.
2-2-1 Dynamic IP
The Host Name is optional, but may be required by some Service
Providers. The default MAC address is set to the WAN's physical
interface on the Broadband Router. If the Service Provider requires the
MAC address, type it in. Click the "Clone MAC Address" button to copy
the MAC address of the Network Interface Card installed in the PC. The
WAN MAC address will be replaced by this MAC address.
If your ISP is BigPond (Australia), check the Enable box.
24
2-2-2 Static IP
If the Service Provider has
assigned a fixed IP address,
enter the assigned IP
address subnet mask and
gateway address provided.
Click “yes” if are using two
or more IP addresses.
2-2-3 PPPoE (Dial-up xDSL)
If you’re connecting to the
Internet using a PPPoE (Dial-
up xDSL) Modem and your
ISP has provided you with a
Password and Username,
then your ISP uses PPPoE.
Select this option, and enter
the required information. If
the ISP provided a Service
Name, enter it in the Service
Name field. Otherwise, leave
it blank.
The Service Name, IP Address, and DNS Address fields must be
completed if your ISP provides you with this information. If your ISP
provides a Dynamic IP Address, skip these fields.
