A SERVICE OF

logo

Introduction
7
3. Connect WAN Cable
Connect the DSL or Cable modem to the WAN port on the TW100-BRF114U. Use the
cable supplied with your DSL/Cable modem. If no cable was supplied, use a standard ca-
ble.
4. Connect Printer Cable
Use a standard USB printer cable to connect your printer to the USB Printer port on the
TW100-BRF114U.
5. Power Up
Power on the Cable or DSL modem.
Connect the supplied power adapter to the TW100-BRF114U and power up.
Use only the power adapter provided. Using a different one may cause hardware damage
6. Check the LEDs
The Power LED should be ON.
The Status LED should flash, then turn Off. If it stays on, there is a hardware error.
For each LAN (PC) connection, the LAN Link/Act LED should be ON (provided the PC is
also ON.)
The WAN LED should be ON.
The Printer LED should be ON.
For more information, refer to Front-mounted LEDs in Chapter 1.