Vega U2020 Application Guide
4
To move antennas to the front of the receiver
1.
Using a Phillips-head screwdriver, remove the two bottom screws (bottom panel closest to the front of the
receiver) and the two screws on the rear panel as shown below.
2.
Using a 5/8” (16 mm) socket wrench, unscrew the antenna hex nuts. Then using a small pair of pliers, gently
unscrew the round serrated audio-output connector nut.
3.
Gently slide the PCB out.
4.
Pop out the antenna plugs in the front of the receiver.
5.
Carefully move the antenna connectors to the front panel and insert the connectors through the holes. Make
certain that the internal antenna cables do not lie down directly on the receiver circuitry, as this will affect
performance.
6.
Screw the hex nuts and lock washers back on (being careful not to use excessive force) and slide the PCB back
into the case. Then reattach the two bottom screws.
7.
Pop the plugs into the antenna holes in the rear panel and reattach the audio-output nut and small screws to the
rear panel.
