FT-60R OPERATING MANUAL14
2
)
Direct Keypad Frequency Entry
The desired operating frequency may be entered directly from the keypad.
To enter a frequency from the keypad, just press the numbered digits on the keypad in the
proper sequence.
Examples:
To enter 146.560 MHz, press
[
1
]
[
4
]
[
6
]
[
5
]
[
6
]
[
0
]
To enter 146.5625 MHz (in 12.5 kHz),
[
1
]
[
4
]
[
6
]
[
5
]
[
6
]
[
2
]
3
)
Scanning
Press and hold in either the
[
(
MHz
)]
or
[
(
MHz
)]
key
for one second to initiate upward or downward scanning,
respectively (Manual VFO Scan).
For scanning within a limited sub-band range, from the VFO
mode, press and hold in the
[
V/M
(
PRI
)]
key for one second
to begin scanning toward a higher frequency within the pre-
viously-defined sub-band (Programmed VFO Scan). Details
regarding sub-band setup may be found on page 36.
If you wish to reverse the direction of the scan (i.e. toward a
lower frequency, instead of a higher frequency), just rotate
the DIAL one click in the counter-clockwise direction while
the FT-60R is scanning. The scanning direction will be re-
versed. To revert to scanning toward a higher frequency once
more, rotate the DIAL one click clockwise.
The scanner will stop when it receives a signal strong enough to break through the Squelch
threshold. The FT-60R will then hold on that frequency according to the setting of the
“RESUME” mode (Set Mode Item 34: RESUME). Press the PTT switch momentarily to
cancel the scanning. This only stops the scan; it does not cause transmission to occur. See
page 35 for details regarding Scan Operation.
OPERATION
FREQUENCY NAVIGATION
(
Programmed VFO Scan
)
(
Manual VFO Scan
)
