30
The specifications of your drive must match with the drive table. The
hard disk will not work properly if you enter incorrect information in this
category. Select “Auto” whenever possible. If you select “Manual”,
make sure the information is from your hard disk vendor or system
manufacturer.
Below is a table that details required hard drive information when using
the “Manual” mode.
Settings Description
IDE Channel The name of this match the name of the menu.
Settings: [None, Auto, Manual]
Access Mode Settings: [CHS, LBA, Large, Auto]
Capacity Formatted size of the storage device
Cylinder Number of cylinders
Head Number of heads
Precomp Write precompensation
Landing Zone Cylinder location of the landing zone
Sector Number of sectors
Primary PIO Settings: [ Auto, Mode 1, Mode 2, Mode 3, Mode 4]
Primary UDMA Settings: [Disabled, Auto]
