www.vtechphones.com
29
Basic operation
Answering system operation
“Remote access code <current setting>, to change
the setting, press SKIP OR REPEAT, to continue
setup, press SETUP.”
Allows you to call your answering machine and
access messages and the answering system
menu from a remote location.
“Message alert tone <current setting>, to change the
setting, press SKIP OR REPEAT, to continue setup,
press SETUP.”
With the message alert tone on, the
machine will beep to notify you when there
are new message(s).
• You can exit
feature setup
at any time by
pressing PLAY/
STOP.
Listen to, save & delete messages
The system automatically saves your messages until you delete them, and can store approximately
11 minutes of messages, memos, and announcements (up to a maximum of 95 messages). A
message or memo can be up to four minutes long.
The message window will ash to alert you to new, unplayed messages. Once all messages have
been reviewed, the number displayed in the window will stop ashing and glow steadily. If the
system contains both old and new messages, it will play only the new messages. After all new
messages are played, press PLAY/STOP to hear all messages.
Before playing a message, the system announces the day and time it was received. While the
message plays, the message window displays the number of the message. After playing the last
message in a mailbox, the system announces “ End of messages.” If the system has less than ve
minutes of recording time left, it announces the remaining time.
Call screening/intercept
1. Make sure the answering system is on, and set the message playback volume control above level
1 so you can hear the caller’s message.
2. If you decide to answer the call, press TALK/FLASH on the handset.
