![](https://pdfstore-manualsonline.prod.a.ki/pdfasset/f/d8/fd8fe807-a802-4cac-856e-1f84106616f9/fd8fe807-a802-4cac-856e-1f84106616f9-bg5.png)
Using your freezer
Setting the temperature control...
1 Insert a coin In the slot of the Temperature Control to
turn it.
2 Turn control to Number 3 This setting IS designed to
maintain the temperature at or near O’F (
17.8 C)
under normal operating condrtions
The sliding basket...
Can be moved from side to side or removed when
loadrng or unloading food below it
To remove:
Loft basket out
To replace:
Lower basket intc place
The key eject lock...
can help reduce the hazard of child
entrapment
The signal light...
automatically warns of any unexpected power
failure.
If the signal light IS not glowing, rmmedrately check
l
for power Interruptron,
l
for an unplugged power cord,
l
for a burned out signal lrght
I
LB
J
Adjusting the temperature control...
1 Turn control to higher number for colder temper-
atures
2 Turn to lower number for less cold temperatures.
Cooling freezer first...
1 Allow freezer to cool 6 to 8 hours before filling with
frozen food.
2 Let It cool overnight before addlng large amount
of
unfrozen food.
NOTE:
When freezer IS first started the compressor will
run constantly until the cabinet is cooled. It may take
up fo 6 to 8 hours or longer, depending on room tem-
perature and the number of times the freezer lid is
opened.
After the cabinet IS cooled the compressor wtll turn
on and off as needed to keep freezer at proper
temperature
To lock or unlock the freezer you must hold the
key In the lock while turning The lock IS spring
loaded so the key cannot be left in the lock
If the key IS lost, conract your WHIRLPOOL
dealer for a replacement Always grve the
com-
plete model and serial number of your freezer
when requesting a replacement key.
To replace:
1. Unplug power cord from outlet
2 Carefully snap out light cover
and assembly
with a
screwdriver by inserting It under the end of metal
edge of the light. Be careful not to chip finish on
freezer.
3 Unplug burned out signal light and replace with a
new one. Signal light can be ordered from your
WHIRLPOOL dealer.
4. Then, snap light assembly into place
5 Plug power cord into outlet.
5