Reversing the door swing. .,.
You can change the hinges on your refrigerator so
the doors open the other way, Refer to the instruction
sheet included with your refrigerator.
Changing the light bulb...
WARNING: Before removing a light shield for
cleaning or for replacing the bulb,
unplug the refrigerator or turn off the
electrlclty leadlng to the refrlg-
erator at the maln power supply.
Shock and Injury could occur.
Light bulb behind light shield:
1. Push lightly on top center of the light shield until the
notched tab unhooks from the control panel
2. Pull down on the shield until the tab clears the con-
trol panel.
3. Lift the back hooks out of the slots.
4. Replace with a 40.watt appliance bulb
5. Replace light shield in reverse order
Optional automatic ice maker.. .
l
It is normal for ice crescents to be attached by a
corner. They will break apart easily.
l
You will hear water runnina when ice maker is
lower Slgnal
Arm to Start It.
working. You’ll hear ice fall%to the bin. Don’t let
these sounds bother you.
I r&e
7
l
The ice maker will not operate until the freezer is
cold enough to make ice. This can take overnight.
l
Because of new plumbing connections, the first
:on
Al
ice may be discolored or off-flavored. Discard the
first few batches of ice.
Ra - ise Signal
Arm to Stc
-. ,p Ice Maker.
l
If Ice is not being made fast enough and more ice
is needed, turn the Temperature Control toward a
higher number. Wait a day and, If necessary. turn
the Air Control toward A.
l
If you remove the Ice brn, raise the signal arm to
If you have the automatic ice maker accessory or
plan to add one later (Part No. ECKMF-61). there are a
few things you will want to know:
l
The ON/OFF lever is a wire srgnal arm.
Down...fcr making ice automattcally.
Up...toshut off the ice maker.
l
Shake the bin occasionally to keep cubes sepa-
rated, and to obtain increased storage capacrty.
shut off the ice maker. When you return the bin,
push it all the way in and lower the arm to the ON
posrtion.
l
If cubes are stored too long, they may develop an
off-flavor...like stale water. Throw them away. They
will be replaced. Cubes In the ice brn can also
become smaller by evaporation.
l
The ice maker water supply
should not be soft-
ened water.
The chemicals could damage the ice
maker molds.
Removing the base grille.. .
Support Tabs
l
Pull grille outwards as shown
To replace:
l Do not remove Tech sheet
fastened behind grille
l
Line up grille support tabs wtth metal clips
l
Push firmly to snap into place.
l
Close the door.
