Install properly...
1, Check the strength of the floor. It should hold
the weight of a fully loaded freezer.
2. Pick a safe place, indoors, away from in-
flammables such as gasoline.
3. Allow
‘12
inch (1.25 cm] on each side of the freezer
for ease of installation.
4. If the freezer is to be against a wall, you might
want to leave extra space on the hinge side so the
door can be opened wider.
Level freezer...
so the door will stay
open at any position.
1
Levelling
Leg
q
Lower
Start adjustment with the door hinge
side.
1 Slide freezer into place.
2. Remove base grille, (see page 6).
3. Adjust front legs to level the freezer
-To raise front, turn legs in
direction shown.
- To lower front, turn legs in
direction shown,
4. Check with level.
5. After freezer is fully loaded, recheck
with level.
Remove sales labels...
Remove the Consumer Buy Guide label and any
inside
labels before using the freezer
lo remove any remaining glue:
1. Rub briskly with thumb to make a ball, then
remove.
OR
2. Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water] be-
fore removing glue as described in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachioride, etc. These can damage the
material.
NOTE: DO NOT REMOVE the Tech Sheet fas-
tened under the freezer at the front.
-8
.x /%_~.-,“/l>“.i.~,j .1m ,.L .~
.=.<,* -,>,.,a -i
Clean it . . .
Clean your freezer before
using it. See cleaning
instructions on page 7.
Plug it in...
Freezer / II1 iII
\
Power Plug
VI ;R
3-p;ong
grounding plug
Recommended Grounding Method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is required.
It is recommended that a separate circuit serving only
this appliance be provided.
Use a receptacle
which cannot be turned off with a switch or pull
chain. Do not use an extension cord.
Attach retaining clip over power cord plug from
literature package inside the freezer.
