15-112” MIN.
Figure 19
IG
UNIT
1
14-112”
+
CENTER UNIT IN
AVAILABLE OPENING ROOM SIDE
20
. Drill g/64” holes in the window jamb top to
line up with holes in filler frame (see Figure
19). Use two thread cutting screws (Item 13)
to secure unit. If you need additional hold-
ing strength, add to screws at the bottom of
the unit side channels (see Figure 14 on
page 7).
z
Installation
Instructions
CAUTION:
l Be sure air conditioner does not fall out of
window during installation.
l Handle the air conditioner with care.
Watch out for the sharp metal fins on
the front and rear coils.
l Do not use the collected water for drinking
purposes. It is not sanitary.
1
l Unpack mounting parts before installing your air
conditioner. Be sure you have all the necessary
parts (see Figure 20 and 21). This air conditioner
will fit most steel casement windows. A normal
installation can be made with a screwdriver, 5/16”
socket driver, tape measure and drill.
Figure 20
Figure 21
KNURLED KNOB
.@ SCREWS
1. x10x 3f8” Long SM. Screw
4. Knurled Knob Screw
2. Y lo-32 x 3/E” Long Mach. Screw 5. Top Mounting Bracket
3. Bottom fvlounting Bracket
NOTE: Abova Parts (Not Shipped Loose) installed on unit
by factory.
2
. Pick the right window. First, decide what
room(s) you want to cool. Then choose a
window that will allow the air-conditioned
air to flow freely and directly into the room(s)
you want cooled. Remember, it’s difficult to
move air around corners. Choose a window
that’s also near an electrical outlet. (Refer to
the ELECTRICAL REQUIREMENT page
for type of receptacle and wiring needed.) Do
not use an extension cord. To be able to use
the window mounting parts shown in Figure
20, the window should have a minimum
width of 14-l/2” and maximum width of 16”
(see “A” in Figure 22). The window should
have a minimum height of lo-5/8” and
maximum height of 1 l-l/4” (see “B” in
Figure 22).
8
