Figure 13
Repair Parts
KEY
NO. PART NO. DESCRIPTION QTY
1 116600036 Rod Cap 2
2 117220130 Shaft 1
3 116700029 Retaining Ring 2
4 116710120 Washer 1
5 117110002 Sleeve Bushing 2
6 116710067 Thumb Screw M6 x 16 1
7 116410022 Cross Guide 1
8 015100033 Chuck 1
9 116800011 Countersunk Screw 1
10 117200008 Guide Bar 2
11 117610002 Spring 2
12 116600085 Depth Stop 1
13 116600034 Bar Holder 2
14 116430120 Base Plate 1
15 116610051 Handle 1
16 116700023 Hex Nut 1
17 116600033 Support 2
18 116700055 Hex Screw 2
19 015100034 Chuck Key 1
20 116620052 Thumb Screw M6 x 10 1
21 117720017 Rubber Stop 4
Workbench Mounting Only -
for Edge Sanding
1. Use a hole saw to cut a hole no larger than
2 1/4" in the top of your workbench.
2. Center the Drill Guide base around the hole
on the underside of the bench. Push rubber
stopper pieces out. Secure base to the
bench using four 1/4" flat head screws
through holes provided in base (screws not
included). (See Figure 11.)
3. To keep the bit locked in place, adjust the bit
above the bench surface to the desired
position.Tighten the thumb screw in the
cross guide/chuck assembly.
NOTE: With this type of mounting, it is recom-
mended having a material guide or
straight edge secured to the top the
bench.
Figure 11
Edge Sanding
For edge sanding, the Drill Guide can either
be handheld or mounted under the
workbench. (See Figure 12.)
Figure 12
