Xerox WorkCentre 4118 User Guide Page 10-17
Troubleshooting
Faxing Problems Solution Chart
Faded graphics Toner may be low. Remove the Toner Cartridge and shake it gently
to distribute the toner evenly. Then reinstall the
Toner Cartridge.
Ensure that a spare Toner Cartridge is
available.
PROBLEM SUGGESTED SOLUTION
Originals are fed diagonally
(skewed)
Ensure the Document Guides are adjusted to the width of the
original being fed.
Check the original meets the conditions established for use with
this device.
The original is not being printed
on the paper of the remote Fax
even though it is being sent
Ensure the originals were placed face-up in the Document Feeder
or face-down on the Document Glass.
Originals are not sent even if
operations are carried out
normally
Check that the remote Fax is compatible with the machine. This
machine supports G3 communications but not G4
communications.
Originals cannot be received
even if [Start] is pressed
Ensure the bell rings before picking up the handset.
Ensure the handset is not replaced before pressing [Start]. When
answering a call using the handset and a Fax is being received, do
not replace the handset until [Start] is pressed and the phone line
switches to the machine.
Check the telephone cord has not been disconnected.
Check the power plug has not been unplugged from the power
outlet.
Check with the party trying to send the original that there are no
problems with the remote fax.
Paper is not collated Ensure the machine has paper loaded.
Check if a paper jam has occurred.
PROBLEM PROBABLE CAUSE SUGGESTED SOLUTION
