■ SETTING UP
Extend the Legs, slide the Leg Base to
the end of the Base Section.
Insert the Upper Tube Section into the
Leg Base’s Joint Section (Make sure the
protrusion on the position clamp is
facingdown).
After adjusting the height of the Upper
Tube Section, firmly tighten the Wing Bolt
on the Base Section.
Loosen the Wing Nut on the Position
Clamp on the Upper Tube Section, align
the Position Clamp with the Joint and
tighten the Wing Nut. With the Position
Clamp set in place, the stool will be set
to the same height every succeeding
time the stool is assembled.
Attach the Seat to the Upper Tube Sec-
tion and tighten the Wing Bolt.
Repeat steps and to adjust the stool
height.
If this symbol is ignored and the
equipment is used improperly, fatal
injury to persons or serious dam-
age could occur.
If the stool is used in a high position, make sure that
the Upper Tube Section is inserted at least 6cm into
the Leg Base’s Joint Section.Using the stool in a high
position can result in injury due to the stool over turn-
ing, slipping, etc.
Always get off the stool when adjusting the height.
Sitting while making adjustments (suddenly loosen-
ing the screw) may result in pinched fingers or the
stool suddenly dropping causing possible injury to you
back.
Make sure the Wing Nut on the position clamp is se-
cured tightly before using. If it is not tightened, the
seat may suddenly slip. This is extremely hazardous
so please pay close attention.
Do not loosen the bolt that fixes the Leg in place
marked with a “ ”. The stool may become
unstable causing an accident resulting in injury.
WARNING
Joint
Leg
Leg Base
Wing Bolt
Base Section
Seat
Wing Bolt
Drum Key Bolt
Upper Tube Section
Hexagonal Nut
Position Clamp
Line
If the stool is used in a high position, make sure that the
Upper Tube Section is inserted at least 6cm into the Leg
Base’s Joint Section.
The line on the upper pipe indicates the minimum required
depth.
