102 Chapter 8—Bus Outs
01V96—Owner’s Manual
Viewing the Stereo Out and Bus Out Settings
You can view and adjust parameter settings for the currently-selected Stereo Out or Bus Out
on the View | Parameter and Fader pages.
■ Viewing the Compressor and EQ Settings
To display the View | Parameter page, use the corresponding [SEL] button to select the
desired bus, then press the DISPLAY ACCESS [VIEW] button, then press the [F1] button.
The parameters on this page (and the procedure for setting them) are the same as for Input
Channels, except for the following items:
•The Stereo Out and Bus Out 1–8 Parameter pages do not contain the Gate and Phase
parameters.
•The Stereo Out Parameter page does not contain the Pair parameter.
■ Viewing Faders and Other Parameters
To display the View | Fader page, use the corresponding [SEL] button to select the desired
bus, then press the DISPLAY ACCESS [VIEW] button, then press the [F2] button.
The Fader page layouts for Stereo Out and Bus Out 1–8 are slightly different.
• Stereo Out Fader page
A BAL
This control adjusts the level balance between the L and R channels of the Stereo Out.
B ON/OFF
This button turns the Stereo Out on or off, and links with the [ON] button in the STE-
REO section.
1
2
3
