20
Something not working
If the aplliance is not working correctly, please carry out the following checks, before contacting your local
Zanussi Service Centre.
IMPORTANT:
If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or
installation, a charge will be made even if the appliance is under guarantee.
SYMPTOM
■ There is no spark when lighting the gas
■ The gas ring burns unevenly
■ The oven does not come on
■ The oven temperature light does not come on
■ The oven light does not come on
■ It takes too long to finish the dishes, or they are
cooked too fast.
■ Steam and condensation settle on the food and the
oven cavity.
■ The timer does not work
■ The oven fan is noisy
SOLUTION
◆ Check that the unit is plugged in and the electrical
supply is switched on
◆ Check that the RCCB has not tripped (if fitted)
◆ Check the mains fuse has not blown
◆ Check the burner cap and crown have been
replaced correctly, e.g. after cleaning.
◆ Check the main jet is not blocked and the burner
crown is clear of food particles.
◆ Check the burner cap and crown have been
replaced correctly, e.g. after cleaning.
◆ Check the oven is in manual operation and that
both a cooking function and temperature have been
selected.
◆ Check the oven is wired in properly, and the
socket switch or the switch from the mains supply to
the oven are ON.
◆ Select a temperature with the thermostat control
knob
◆ Select a function with the oven function control
knob.
◆ Check the light bulb, and replace it if necessary
(see "Replacing the Oven Light")
◆ The temperature may need adjusting
◆ Refer to the contents of this booklet, especially to
the chapter “Using the Oven”.
◆ Leave dishes inside the oven no longer than 15-20
minutes after the cooking is completed.
◆ Check the instructions for the timer.
◆ Check the grease filter is correctly fitted.
◆ Check that shelves and bakeware are not vibrating
in contact with the oven back panel.
