Filter
Top Products
3. Hue :Set the Hue of the video +color to increase red
color, -color to increase green color
4.Saturation- Set the degree of the saturation of the video.
16
1. Downmix: Switch the audio output from LT/RT Mono,
STEREO,VSS and 5.1 CH mode. In LT/RT Mono Mode,
two sound tracks will be mixed and the difference between
these two tracks will be enhance. In VSS mode, two sound
tracks will be mixed and the difference between these two
tracks will be decrease.
Basic Operation-Speaker Setup
2. Sub Woofer You can turn on the sub woofer in 5.1 CH
mode.
3. Center Delay: You can adjust the center speaker delay
according the position of your center speaker.
4. Rear Delay: You can adjust the rear speaker delay
according the position of your speaker.rear
5. Font:
.Change the font to large or samll
Basic Operation-Digital Setup
1. OP MODE: To set the Dolby digital output , you can
switch between Line Out(encode signal) and RF
REMOD(raw signal).
2. Dynamic Range: To set the scale of dynamic range in
Dolby digital logic sound effect.
3. Dual Mono: ,In Dolby sound effect to set the Dual Mono
modes from STEREO, MONO L, MONO R and MIX MONO