Filter
Top Products
Chapter 3. Operation
61175408L1 Quad FXS Voice Module User Manual 3-3
QUAD FXS VOICE MODULE MENU OPTIONS
Figure 3-1 shows themenu options available for the
Quad FXS Voice Module.
The following sections describe these options.
Figure 3-1. Quad FXS Voice Module Menu Options
PRT
Identifies the port involved.
MODE
Options are given below.
L
OOP
S
TART
Sets the port to use FXS loop start signalling on theT-span and loop start
supervision on the analog 2-wire interface.
G
ROUND
S
TART
Sets the port to use FXS ground start signalling on theT-span and ground
start supervision on the analog 2-wire interface.
TR08 S
INGLE
Sets the port to use Single Party Channel Unit signalling on theT-span (as
defined by TR-TSY-000008) and loop start supervision on the analog 2-wire
interface.
TR08 UVG Sets the port to use UniversalVoice Grade signalling on theT-span (as
defined by TR-TSY-000008) and either loop start or ground start supervi-
sion on the analog 2-wire interface.
DPO Sets the port to use Dial Pulse signalling to originate dialed numbers.
T
ANDEM
(E&M) Sets the port to use E&M signalling on theT-span and either loop start or
ground start supervisionon theanalog 2-wire interface. See the Tandem sub-
menus for more information.