Alesis 12 FireWire, 16 FireWire Musical Instrument User Manual


 
Contact Information
60
rectangular rackmount units.
EQ (equalizer)
T
he part of your mixer (or other device) that manipulates an audio signal
by lowering the level of some frequencies and increasing the levels of
others. EQ is used to fine-tune a signal’s highs and lows.
fader A device that allows you to control the level of an audio signal by sliding
the fader up and down a straight path. Each input channel of the
MultiMix has its own fader, and so do the MAIN MIX and ALT 3/4.
Firewire A standard for connecting external devices to a computer. Also called
IEEE 1394a.
gain The measure of extra amplification applied to an audio signal. Channels
1 – 4 on your MultiMix have gain controls, which are useful for boosting
mic and line signals.
IEEE 1394a Another name for Firewire (see above).
latency The time it takes for audio to travel from the MultiMix, through the
computer and the recording program, and out again. Latency is
measured in either samples or milliseconds.
level The amount of power driving an audio signal. The most common
names given to levels of varying voltage are, from lowest to highest,
microphone level, instrument level and line level.
master section The section of a mixer where the main mix is controlled.
mic preamp An amplifier that boosts a microphone-level signal up to line level.
mixer A device whose purpose is to combine and output a number of audio
signals, allowing various types of signal manipulation.
mono (monaural) Refers to an audio signal that has only one channel. The opposite of
stereo.
pan
A
control that lets you position a mono signal within the stereo spectrum
by altering the level of the signal being sent to the left channel as
opposed to the right.
phantom power A way of providing power to condenser microphones. Called
“phantom” because the power isn’t apparent to dynamic microphones
when you connect them to an input that provides phantom power.
post-fader Describes an aux send that sends a signal that already has passed through
the channel fader.
pre-fader Describes an aux send that sends a signal that has not passed through the
channel fader.