Filter
Top Products
13
- SUB1-2/SUB3-4/MAIN MIX
25
26
- AUX RETURN SOLO
The function of AUX RETURN SOLO is like the channel SOLO button. Engaging it sends the signal from AUX
RETURN (1-4) to the CTRL OUT, PHONES outputs and METERS display. It can also be affected by SOLO
mode button, and the LED next the button will illuminate.
27
- SUBGROUPS ASSIGN TO MAIN MIX
Through these switches, you can operate the subgroup faders as a master control for assigning the subgroups
to MAIN MIX. Engage the LEFT switch to send the corresponding subgroup signal to MAIN MIX L, and the RIGHT
switch for MAIN MIX R. When engaging the both switches, the signal will be sent to L/R of MAIN MIX.
28
- SUBGROUPS
These faders are used to control the levels of signals sent to the SUBGROUPS OUT, the adjustable range is
from - to +10dB. Any channel that is assigned to the subgroups, not muted and not turned down will be assi-
gned to the SUB OUTS.
29
- MAIN MIX LEVEL
This fader sets the amount of signal sent either to the Main Mix Output sockets or to the Tape Output.
30
- LED METER
The stereo 12 segments LED Meter will indicate the signal level sent to CTRL ROOM and PHONE outputs.
31
- 2TK TO MIX
Engaging this switch allows you to combine the 2 TRACK Output with the MAIN MIX. In other words, feeds the
2TRACK IN signals into MAIN L/R output.
32
- SOLO MODE
This button provides two modes: up for PFL (Pre-Fader-Listen) mode, and down for AFL (After-Fader-Listen) mode.
Engage the button, the soloed signal will output following the LEVEL control, otherwise, release the button will
output the soloed signal before the level control
Please note that the SOLO function can never affect the mix at main recording output, and also can't be affected
by channel's MUTE switch.
These three buttons are configured for AUX RETURN4, they can be regarded as the signal assignment switches.
Engage the SUB1-2 button to assign the stereo signal from AUX RETURN4 to Submix1/2; in the same way,
SUB3-4 for Submix3/4, MAIN MIX for MAIN MIX buses.