Filter
Top Products
Audio® or American DJ® “Q” Start CD player. When used with a compatible CD player, you can use the
crossfader to start and stop the CD play. The ON/OFF “Q” START switch activates the fader “Q” start
feature. When the fader “Q” start feature is activated sliding the CROSSFADER (10) from left to right
will play or cue any CD player connected to the CONTROLLER JACKS (16) on the rear of the unit.
For example, connect a compatible dual CD player connect to mixer channels one and two
(refer to your CD player manual for proper set-up). Be sure the Fader “Q” Start feature is
activated on both channels. Slide the crossfader to the channel one position (full left) and
begin playback on CD drive one. Slide the crossfader to the channel position (far right). This
will immediately trigger the play function on CD drive two and return CD drive one to cue
mode. To return to normal fader operation turn the Fader “Q” Start ON/OFF SWITCH to the
OFF position.
12. CHANNEL 2: AUX 2 JACK - This Aux input is for the use of a Mp3 player. Input volume will be
controlled by the channel two
fader.
13. MICROPHONE SECTION - These controls are used to adjust the microphone volume level, treble
level, and bass levels.
MICROPHONE VOLUME - This knob is used to regulate the microphone output volume. Turn-
ing the knob in a clockwise direction will increase the volume level.
MICROPHONE TREBLE CONTROL - This knob is used to adjust the treble levels of the
Microphone with a maximum signal gain of 10dB or maximum signal decrease of -10dB.
Turning the knob in a counter-clockwise direction will decrease the amount of treble
applied to the microphone signal, turning the knob in a clockwise direction will increase
the amount of treble applied to microphone signal.
MICROPHONE BASS CONTROL - This knob is used to adjust the low frequency levels of
the microphone with a maximum signal gain of 10dB or maximum signal decrease of -10dB.
Turning the knob in a counter-clockwise direction will decrease the amount of bass applied to
the microphone signal, turning the knob in a clockwise direction will increase the amount
of bass applied to microphone signal.
14. TALKOVER CONTROL - This function decreases all signal output except for the microphone
signal.
15. MASTER VOLUME LEVEL INDICATORS - The dual MASTER LEVEL LED indicators are used to
detail the master output level. The meters will detail the output level of both the left and right chan-
nels.
©American Audio® - www.americanaudio.us - Q-D6™ Instruction Manual Page 9
Q-D6™ Controls and Features Cont.