Filter
Top Products
©American Audio® - www.americanaudio.com - WM UHF16™ Instruction Manual Page 5
WM UHF16™ RECEIVER CONTROLS AND FUNCTIONS
1. Antenna - Receives RF signals from the transmitter.
2. Balanced XLR Output - This balanced XLR output can be used to connect the receiver to bal-
anced input of mixer or amplifier.
3. Unbalanced 1/4” Output - This unbalanced output can be used to connect the receiver to the
aux-level input of a mixer or amplifier.
4. 12v DC Input - Connect the included power supply to this input, or any other 12v power adapter.
5. Main Power Switch - This is main power ON/OFF switch for the receiver. A red LED on the
switch should glow indicating that the power is ON.
6. Channel Frequency Knob - Use this knob to choose the receiver operating frequency. The trans
-
mitter must be set to the same frequency. You can change the channel with a small flat head screw-
driver.
7. Volume Knob - Controls the volume of the receiver output.
8. AF Indicator LED - This LED will indicate when the clearest transmitter signal has been reached.
9. RF Indicator LED - This LED will flicker when receiving a signal from the transmitter.
98765
1 432