Filter
Top Products
B. MASTER mode
9. F+SIGNAL SELECT+RESET BUTTONS
10. DMX indicator blinks when preheat is effective, otherwise lights.
11. SIGNAL indicator blinks when DMX signal is available and goes out when not available.
Press to perform a reset for the whole system, which enables to return to initial condition.
9. F+SIGNAL SELECT+RESET BUTTONS
10. MASTER indicator blinks when preheat is effective.
11. SIGNAL indicator goes out.
12. FULL ON & STAND BY(Located on the remote control)
WARNING
Press to perform a reset for the whole system, which enables to return to initial condition.
FULL ON and STAND BY are effective only in MASTER mode. Press FULL ON to activate full on function of
whole channel output, DISPLAY shows FUL. Press STAND BY to turn off whole channel, and STD appears.
1. This apparatus must be earthed.
2. To prevent fire or shock hazard, do not expose this apparatus to rain or moisture.
3. Wait for at least one second to turn the main power on after turning off the main power.
4. If malfunction occurs, reset to restart this unit.
5. This apparatus is suitable for normal pollution situation.
6. When this apparatus is used in connection with other unit, Start Code is 55H(85D)
7. When the current of whole unit exceeds max. permit table current, external circuit breaker will
shut down the circuit automatically.
When the MASTER indicator is on, this unit is used as a DMX chase controller.
1. BUTTONS 1, 2, 3 and 4
1. Press to enable to display desired channel dimming level, corresponding indicator will blink, then select
desired dimming level using UP or DOWN button.
These 4 buttons are effective only when MANUAL DIMMER indicator is on.
Press F+PRESET buttons to withdraw from this condition, the indicator won't blink.
2. UP BUTTON
3. DOWN BUTTON
6. F+MODE BUTTONS
7. F+SIGNAL SELECT BUTTONS
8. F+PRESET BUTTONS
Press to select available parameter information used with UP and DOWN buttons.
This function is effective only in MASTER mode. The operating modes are changed in order of:
Press to select desired operating mode.
Press to select operating mode from MASTER to DMX mode, and the DISPLAY will show IN.
5. F+D/S BUTTONS(Press F and D/S buttons at a time.)
Press to select CRO or NOR.
NOTE: NOR refers to 0-100% dimming.
CRO denotes only FULL ON and STAND BY are available.When dimming level is greater than 50%,
FULL ON is activated, otherwise, STAND BY is effective.
4. F+ BUTTONS(Press F and buttons at a time.)
Press to select L-- or R--.
NOTE: L-- refers to data information of CH.1,CH.2, CH.3 and CH.4 corresponding to 1, 2, 3 and 4 output.
R-- refers to data information of CH.1, CH.2, CH.3 and CH.4 corresponding to 4, 3, 2 and 1 output.
Press to decrease the display value.
Press to increase the display value.
PARAMETER
FUNCTION
MANUAL DIMMER
AUTO SOUND
MANUAL PROGRAM
PROG SOUND
AUTO PROGRAM
HOLD SOUND
F00-F99
FADE TIME(0-10S)
DIMMER(0-100%)
PRESET MINIMUM DIMMING LEVEL(0-25%)E00-E25
00- FF
P
P