Filter
Top Products
BA-210SP Bassamp Cube with Digital Effects
5
11. EFFECTS LEVEL: Use this control to
adjust the level of the selected digital
effect.
12. CD INPUT: Use these RCA jacks to
connect the line level (or headphones)
output of a CD player, tape deck or rhythm
machine to the amplifier. The inputs to
these jacks are summed into a mono sig-
nal which is fed into the BA210SP’s power
amplifier. The signal level from these jacks
is adjusted by the amplifier’s Level control
(#8). If the signal from the source connect-
ed to these jacks is too strong, use the
output level control on the source to adjust
the signal to obtain the proper level for a
good mix.
13. HEADPHONES: Use this jack to listen
to the amplifier through a pair of stereo
headphones. The internal speaker is dis-
connected when the headphones jack is
used.
14. FOOTSWITCH: Use this jack to con-
nect the supplied two button footswitch to
the amplifier for remote control of the digi-
tal effects. For information on program-
ming the footswitch, see page 7.
15. BAL. LINE OUT: This jack supplies a
post-eq, balanced line level signal for con-
necting to a house sound board, recording
unit or external amplifier.
16. POWER: Use this switch to turn the
amplifier on or off. The adjacent LED will
illuminate when the amplifier is turned on.
17. A C L I N E C O R D (rear panel, not
shown): This heavy duty, grounded, three
wire power cord is to be plugged into a
safely-wired, grounded, 120 volt, 60 cycle
A C power outlet. DO N O T attempt to
defeat the ground connection of this cable!
If your amplifier was purchased outside of
the United States, see the unit’s rear panel
for its power and voltage ratings and follow
the above guidelines.