Filter
Top Products
7
SVT-350H
Troubleshooting
In the unlikely event that your SVT-350H should stop working properly (or just stop working), take a few minutes to trou-
bleshoot it before you call for service. You can save yourself a lot of time and sometimes money by doing it yourself, and
often the cure for the problem is something quite simple.
If the problem isn’t covered above, or if the steps lead you here, then contact your Ampeg dealer for service infor-
mation. Also, you should refer your amp to an authorized service center for servicing if it gets dropped, has liquid spilled
into it, or sustains damage to its power cord.
System Block Diagram
NO SOUND
LEDs LIGHT
POOR SOUND
Check bass, cables
Check speaker(s)
Replace speaker(s)
POOR SOUND
LEDs DON'T LIGHT
Check AC outlet
NO SOUND
NO HUM HUM
Listen for hum
NO CHANGE
SOUND OK
SOUND OK
POOR SOUND SOUND OK
SOUND OK
Check amp controls, check
for signal from bass
Check power cord,
fuse, power switch
Check house fusebox
or circuit breaker
SPEAKER(S) OK,
POOR SOUND
SPEAKER(S)
DEFECTIVE
Check speaker Unplug bass,
touch tip of cable
Speaker OK
Replace cable
NO CHANGE
SEE BELOW SEE BELOW
NO OUTLETOUTLET OK
OK
0dB
PAD
POST
PRE
-20dB PAD
LIMIT
ON
COOLING
FAN
POWER AMP
PROTECTION
RELAY
Thermal Shutdown,
Low Voltage,
DC Protect
EFFECTS
SEND
BALANCED
LINE OUT
GAIN
BASS
MASTER
VOLUME
ULTRA MID
TREBLE
PEAK
LED
9 BAND
GRAPHIC
EQ
EFFECTS
RETURN
PREAMP
OUT
EQ
IN
SPEAKER
OUT
POWER AMP
IN
SPEAKER
OUT
SPEAKON
JACK
1+
2+
1- 2-
LIMIT
LED