Filter
Top Products
6
Connections
SVT-5 PRO Bass Amplifier
MONO BRIDGED: The SVT-5 PRO’s two internal amplifiers are bridged together to produce maximum output power.
• Full Range/Biamp switch out (full range), Stereo/Mono switch depressed (mono)
• Connect a heavy duty speaker cable (
) from the SVT-5 PRO’s Mono Bridge/Biamp Speakon
®
jack to the input of a full range speaker cabinet
• Speakon
®
pin 1 + = signal “+,” pin 2+ = signal “–”
MONO
BRIDGE
SVT-5 PRO
IN
OUT
(MONO)
1
TO
INPUT
JACK
FULL RANG
E
CABINET(S)
NOTE: BE
ABSOLUTELY
CERTAIN THAT
THE CABINET(S)
ARE ABLE TO
HANDLE THE
EXTREMELY
HIGH OUTPUT
POWER OF THE
AMP IN THIS
MODE!
(FULL
RANGE)
Mono
Bridged
DUAL MONO: The SVT-5 PRO’s two internal amplifiers will each power a full range cabinet.
• Full Range/Biamp switch out (full range), Stereo/Mono switch out (stereo)
• Connect a heavy duty speaker cable (
) from the SVT-5 PRO’s Power Amp A jack to the input of a full range speaker cabinet
• Connect a heavy duty speaker cable (
) from the SVT-5 PRO’s Power Amp A jack to the input of a full range speaker cabinet
SVT-5 PRO
TO
INPUT
JACK
TO
INPUT
JACK
FULL RANG
E
CABINET(S)
FULL RANG
E
CABINET(S)
OUT
OUT
(STEREO)
12
(FULL
RANGE)
PWR
AMP B
PWR
AMP A
Dual
Mono
BIAMP - Full Range / Lows: One of the SVT-5 PRO’s internal amplifiers will power a full range cabinet, the other will power a low frequency cabinet.
• Full Range/Biamp switch out (full range), Stereo/Mono switch out (stereo)
• Connect a signal cable (
) from the SVT-5 PRO’s Biamp Low Output jack to its Amp A Power Amp Input jack
• Connect a heavy duty speaker cable (
) from the SVT-5 PRO’s Power Amp A jack to the input of a full range speaker cabinet
• Connect a heavy duty speaker cable (
) from the SVT-5 PRO’s Power Amp A jack to the input of a full range speaker cabinet
SVT-5 PRO
TO
INPUT
JACK
TO
INPUT
JACK
FULL RANG
E
CABINET(S)
LOW FREQ.
CABINET(S)
OUT
OUT
(STEREO)
2
1
3
(FULL
RANGE)
PWR
AMP B
BIAMP
LO OUT
PWR
AMP A
AMP A
PWR
AMP
INPUT
Biamp - Full
Range / Lows
Use the Crossover Frequency control (#28)
to set the crossover point for the low output.