Filter
Top Products
RECEIVER OPERATION
Each unit provides two selectable receiving frequencies.
1) Switch the Frequency Selector Switch to the same channel as the
one selected on the transmitter (A or B)
2) Attach the receiver to the amplifier by inserting the mounting
bracket foot into the amplifiers accessory shoe (if available) or with
the supplied Velcro.
3) Connect the mini-plug audio signal cable from the phone out jack
on the receiver to the wireless mic jack on amplifier
4) Attach Antenna by screwing it into socket on top of receiver.
5) Turn the Power ON/OFF switch to the ON position (The LED
indicator will light)
HELPFUL HINTS
A) If the selected channel is noisy, switch both the transmitter and
receiver to the other channel.
C) Low ceiling fluorescent lighting, overhead telephone lines, or close
proximity to metal fences can all cause static. If this occurs, try a
slight change of position and/or try changing frequencies.
D) When the battery voltage drops below 6V, the LED indicator will
go out. This means you need a new battery.
E) Be sure to turn off the power whenever the units are not in use,
and remove the batteries if the units will be out of service for a
long time.
NOTE: There are no user-adjustable parts inside the transmitter or
receiver Do not attempt to open or make any adjustments.
Phone Out Jack
Wireless Mic Jack