Atlas Sound TSD-MIX31RL DJ Equipment User Manual


  Open as PDF
of 8
 
Owner’s Manual
TSD-MIX31RL
3x1 Mic/Line Mixer
AtlasSound.com – 4 –
Specifications are subject to change without notice.
1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.
Telephone: 800.876.3333 • Fax: 800.765.3435
Rear Panel Description
TSD Input/Output connections are removable for easy system wiring. The connector has a 3.5mm
pitch between pins.
1. DC Power Input - Each TSD that requires DC power comes with a 2 position connector for
an external 24VDC power supply (sold separately). Because of the low power consumption, a
single external power supply may power more than one TSD. Refer to the current requirements in
milliamps to match with the appropriate power supply. Note: It is acceptable to exceed the current
of the TSDs but NOT safe to use a power supply that is below the current requirement of the device.
2. Balanced Inputs 1 and 2-Connectstobalancedlineormiclevelsources.Forgainorsourceinput
typeselection,refertothe“DipSwitchFunctionIdentication”chart.Note:Unbalancedlineinputs
can be inserted with proper wire configuration by connecting the (G) and (-) terminals together.
3. Unbalanced Input 3 - Electronically sums unbalanced audio signals through stereo RCA
connectors. Level control is on the front panel . Input 3 can be muted via contact closure or an
audio signal on Input 1 for priority paging applications.
4. Input 3 Remote Mute - Connect a dry contact closure across these two terminals to mute Input 3
when the switch is closed. Dip Switch 7 must be in the On position.
5. Remote Level-Forremotegaincontrol,connecttheAtlasSoundAAVC-10K(orequal)wallplateto
this terminals. Set Dip Switch 8 to control a mixed signal or Input 3 signal only.
6. Balanced Line Output - Provides output for connection to balanced mic/ line level devices. Note:
Unbalanced line level devices can be used with proper wire configuration by connecting the (G)
and (-) terminals together.
7. Output Limiter Control - Sets peak output levels by increasing or decreasing the sensitivity.
TheLimiterLEDonthefrontpanelindicateswhenlimiterisinuse.Note:Thecontrolknobcanbe
replaced with a supplied security cover to prevent unauthorized adjustment.
8. Vox Sense - Adjusts the sensitivity of the Mute circuit for priority pages. Set Dip Switch 8 to
control a mixed signal or Input 3 signal only.
9. Cable Management Retainer Points - Use rear panel screws to secure included cable
management retainers.
3
7
2
99
9 9
4
5
6
1 8
 previous next