Filter
Top Products
1. CLIP LED: Will illuminate at +14dBu, giving a 6dBu warning of the impending distortion at +16dBu, the
actual clip point.
2. LO CONTOUR: Regulates the amount of phase corrected bass frequencies.
3. PROCESS: Regulates the amount of phase corrected treble frequencies.
4. BBE FUNCTION: This push button switch allows for quick comparison of processed with unprocessed sound.
When the switch is pushed in, the process is on and the indicator LED is green. When the switch is out, the process
is off and the indicator LED is red.
5. POWER: This switch controls primary power to the BBE 362XL.
REAR PANEL CONNECTIONS
1. AC POWER CORD: Plugs into AC power receptacle. U.S. Model, 100-120Vac, 50/60Hz.
All other models, 200-240 Vac, 50/60Hz.
2. FUSE: Turn cap on fuse holder counter-clockwise to remove fuse. (Note: For U.S. Model, replace with
250Vac, 1/2A Fastblow type fuse. For all other models, replace with 250Vac, .125A Fastblow type fuse.)
3. OUTPUT: The output of the BBE 362XL can be taken from the 1/4” stereo TRS Phone Jack or the XLR Jack. Both
are balanced and the same point electronically. This allows both outputs to be used simultaneously, eliminating the
need for a “Y” cord in the event multiple, balanced outputs are required. The recommended single load impedance
is at least 10k Ohms. If both outputs are being used, a minimum of a 22k Ohm load per device is required. (The
“load” is determined by the input impedance of the next subsequent component in the signal chain.) The
maximum output is rated at +26dBu. Pin #2 is considered the hot or “+” signal. The output impedance of the BBE
362XL is 600 ohms. NOTE: Actual output level will vary due to the selected position of the BBE Process, and the
actual input signal level. If both the XLR and Phone Jacks are being used, both must be either balanced or
unbalanced. Otherwise a loss of signal level will occur.
4. INPUT: The input of the BBE 362XL is a balanced connection. Although is can be either a TRS 1/4” stereo Phone
Plug or an XLR Plug, it is recommended that only one input source be used. Both jacks are the same point
electronically, however, due to the input/output impedance characteristics of most audio devices, a loss of signal
may occur and/or damage to a component if both inputs are utilized. Pin #2 is considered the hot or “+” signal. The
input impedance of th BBE 362XL is 10k Ohms. The maximum signal level is +26dBu.
3
FRONT PANEL CONTROLS
1
1
2
2
3
3
4
4
5