Filter
Top Products
FRONT PANEL CONTROLS
1. LO CONTOUR CONTROL: This control adjusts the amount of
phase corrected bass frequencies.
2. PROCESS CONTROL: This control adjusts the amount of phase
corrected treble frequencies.
3. BBE FUNCTION: This switch allows for the quick comparison of
the processed and unprocessed sound.
4. INPUT PAD: This switch allows the user to select between an
instrument input (input impedance = 1 MEG OHMs), or a line level
input (input impedance = 12k OHMs).
5. INPUT JACK: This is a 1/4” phone jack for signal insertion. Input
signal can be from an instrument, or line level from a preamp.
Connecting a 1/4” mono phono plug to this input activates the internal 9
volt battery and will power the DI-100 for approximately 100 hours.
REAR PANEL CONNECTIONS
6. D.C. INLET: This jack is for connecting the VDC power source.
The 9 VDC power plug must be of the type where the positive voltage
is on the outer ring.
7. GROUND LIFT: This switch is used to lift the units ground connec-
tion from pin 3 the XLR balanced output.
8. BALANCED OUTPUT: This XLR jack provides a mic level, bal-
anced output. Pin 2 being the ‘Hot’ pin. The DI-100 can also be phan-
tom-powered through this XLR jack.
9. UNBALANCED OUTPUT: This 1/4” phone jack provides an
unbalanced line level output.
NOTE: This unit may be powered by three (3) different modes.
1. Internal 9 volt battery.
2. 9 VDC external power source.
3. 48v phantom power source.
NOTE: When using phantom powering, XLR ground lift must be off.
BBE DI-100 INSTALLATION INSTRUCTIONS - 3
1 2 3 4 5 6 7 8 9