Filter
Top Products
ENGLISH
EUROPOWER PMP960M/PMP980S/PMP1280S User Manual
10
Wiring Examples5.
For stereo operation the POWER AMP switch (28) of the
PMP980S/PMP1280S must be set to its upper position (MAIN L/
MAIN R). Outputs A and B deliver the stereo main signal to the
P.A. speakers. Two active speakers, wired in parallel, are
connected to the preamp monitor output. They are used as
on-stage monitor speakers. The effects processors can be
switched on and off with a dual footswitch. This set-up is not
possible with the PMP960M (no stereo operation possible).
Both the PMP980S/PMP1280S and the PMP960M can be set-up
for dual mono operations. The POWER AMP switch (28) must be
set to its lower (PMP960M) or center position (PMP980S/
PMP1280S). The two loudspeaker outputs provide the main and
monitor signals independently of each other and to two loud-
speakers each, which are wired in parallel.
TIP = FX 1
RING = FX 2
FOOTSW
FX
U
TPUT
MONITOR
Fig. 5.1: EUROPOWER mixer as a stereo amplier (example)
Fig. 5.2: EUROPOWER as a dual mono amplier (example)