Filter
Top Products
10 EUROPOWER PMP1680S/PMP980S/PMP960M User Manual
strain relief clamp
sleeve
tip
sleeve
pole 1/ground
tip
pole 2
The footswitch connects both poles momentarily
¼" TS footswitch connector
Fig. 4.4: ¼" TS connector for footswitch
Please use a dual footswitch for the PMP980S/PMP1680S, so that you ◊
can enable/disable FX 1 and FX 2 independently of each other. In this
case, the tip of the ¼" plug controls FX 1, and the ring FX 2.
shield
sleevesleeve
tip tip
Fig. 4.5: RCA cable
Loudspeaker connection4.3
Your PMP mixer is equipped with high-quality twist-lock professional style
loudspeaker connectors, which ensure safe and trouble-free operation.
This connector was especially developed for high-power loudspeakers. Once it is
plugged in, it safely locks into position and cannot be accidentally disengaged.
It prevents the occurrence of electrical shock and ensures the correct polarity.
Each of the connectors carries only the assigned single signal (see tab. 4.1/g. 4.7
and the information on the rear panel of the power mixer).
1-
2-
2+
1+
1-
2-
2+
1+
front view rear view
Professional speaker connector
(compatible with Neutrik Speakon connectors)
Fig. 4.6: Professional twist-lock style connector
Please be sure to only use professional locking-style speaker cables (type NL4FC).
Please check the pin connections of your loudspeakers and cables depending on
the EUROPOWER speaker output you choose.
EUROPOWER PMP980S/PMP1680S
OUPUT A 1+ 1- 2+ 2-
MAIN L POS NEG – –
MON POS NEG – –
OUTPUT B – – POS NEG
OUTPUT B 1+ 1- 2+ 2-
MAIN R POS NEG – –
MONO POS NEG – –
BRIDGE POS – NEG –
EUROPOWER PMP960M
OUTPUT A 1+ 1- 2+ 2-
MAIN MONO POS NEG – –
MON POS NEG – –
BRIDGE – – – –
OUTPUT B 1+ 1- 2+ 2-
MAIN MONO POS NEG – –
MAIN POS NEG – –
BRIDGE POS – NEG –
Tab 4.1: Pin connections of loudspeaker connectors
OUTPUT B
BRIDGE
1+
1+
2+
1+
1- 1-
8 Ω
4 Ω
8 Ω
4 Ω
16 Ω
8 Ω
OUTPUT B
Fig. 4.7: Connector assignment