Filter
Top Products
EURODESK SX3242FX/SX2442FX
Wiring examples12
Wiring examples4.
Studio set-up4.1
The following wiring example shows a studio set-up for 4-track-recording: the drums are mixed down to two subgroups and then
routed via the subgroup outputs to two tracks of the multi-track recorder. The remaining two subgroups are used to record the guitar,
keyboard (stereo channel) and two vocal signals on the remaining two tracks. The four return paths from the recorder are connected
to four separate mono input channels on the EURODESK. The built-in compressor is used only for the bass, which is why this input
channel is separate from all buses (SUB and MAIN switch not pressed). The bass signal is directly routed from the built-in effects
processor to the respective subgroups (FX TO MAIN control). The MAIN/SUB switch in the FX1 section is pressed, but NOT the SUB
1/2 SUB 3/4 button.
Wiring the console for studio operationFig. 4.1:
Please make sure that none of the subgroup routing switches (1-2 and 3-4) is pressed in the channels connected to +
the recorder returns. Otherwise, a feedback loop will be created as soon as you start recording. Only press the MAIN
switch on these input channels, so that the tape return signals are routed to the main outs and Phones/CTRL room
outputs of the console.