Filter
Top Products
7
ULTRAVOICE DIGITAL VX2496
3. RECORDING WITH THE ULTRAVOICE DIGITAL
+ To avoid coloring the character of the sound, do not
set the threshold too low when using the opto
de-esser. When the threshold is set at its optimal
value, the effect should only be recognizable by
direct comparison to the unprocessed signal using
the IN/OUT button.
Use the MASTER FADER to match the output signal level
to the input sensitivity of the following device (e.g. your
DAT or hard disk recorder).
+ Start by tuning the master fader right down and
increase it slowly to the desired level. If you start
with too high a level, you risk overloading the inputs
of the devices that follow!
The six OUTPUT LEVEL LEDs show the level of the output
over a -10 to +15 dB range. Ensure that the output level
does not go into overload otherwise the signal at the
DIG OUT output will be too high and cause distortion.
Use the POWER button to turn on the ULTRAVOICE DIGITAL.
2.6 Rear panel connectors