Filter
Top Products
R-1000 / R-2000 is a VHF high-band non-diversity system with quartz controlled
fixedfrequency design. The receiver must be combined with Califone's Q- and M-
series of wireless microphone.
1. MATCHING WIRELESS MICROPHONE:Q- and M- series such as Q-1000 &
M-1000
1. MAIN FRAME:R-1000 / R-2000
2. ACCESSORIES:1)AC adapter 2)antenna X 1(R-1000) /antenna X 2(R-2000)
3)Output cable / PHONE 4)Operating manual
OUTLINE
FRONT PANEL
GENERAL
CONTROLS AND FUNCTIONS
SYSTEM COMBINATION
COMPOSITION
1. Turn volume control of the receiver as well as the mixer or the equipment to be
used to the minimum then switch on the receiver. The pilot LED of the
receiver will light up and the AF signal indicator will give a flash.
2. When a transmitter is switched on RF signal indicator LED of the receiver
will light up indicating that the system is in normal operation. When indicator
LED of the receiver does not light up indicating that the system does not
match both of the transmitter and the receiver should be checked whether they
are in normal operation or not.
3. When a matching transmitter is switched on at distance within 15 meters away
from a receiver RF signal indicator LED of the receiver does not light up
indicating that the system is matched but is in abnormal operation.
4. When sound is applied to the microphone while the system is switched on and
is in normal operation AF signal indicator will light up accordingly indica-
ting that audio output of the system is in normal operation.
5. AF output level can be adjusted by volume adjustor to match the maximum
input level of the equipment to be used.
6. Audio output level must be adjusted to match a proper input level of the mixer
or the equipment to be used. If output of the receiver is adjusted too high and
volume control of the mixer is turned too low, it will cause the mixer output to be
distorted. Conversely the mixer output will not be distorted but a poor S/N
ratio will be caused.
7. After proper adjusting the output volume of the system adjust volume control
of the mixer or the equipment to be used to get a desired sound level output of
the microphone.
8. Power supply voltage can vary from 12-15V DC
OPERATION OF THE OVERALL SYSTEM
R
R