Filter
Top Products
— 6 —
The following table shows the pin functions of LSI101.
DAC (IC103: UPD6379GR)
The DAC receives 16-bit serial data output from the CPU. The data contains digital sound data of the melody,
chord, bass, and percussion for the right and left channels. The DAC converts the data into analog waveforms
and output them to each channel separately.
Pin No. Terminal In/Out Function
1 TXD0 Out MIDI signal input
2 RXD0 In MIDI signal output
3 SCK0 Out APO (Auto Power Off) signal output
4 ~ 6 Not used. Connected to ground.
7 AVCC In Ground (0 V) source
8, 9 AN0, AN1 Not used. Connected to ground.
10 AGND In Ground (0 V) source
11 BCK Out Bit clock output
12 SO Out Serial sound data output
13 LRCK Out Word clock output
14 GND In Ground (0 V) source
15, 16 XLT0, XLT1 In/Out 20 MHz clock input/output
17 VCC In +5 V source
18, 19 MD0, MD1 In Mode selection terminal. Connected to ground.
20 RSTB In Reset signal input
21 NMI In Power ON signal input
22 INT Not used. Connected to ground.
23 ~ 30
FI0 ~ FI3
SI0 ~ SI3
In Key input signal
31 ~ 38 KC0 ~ KC7 Out Key scan signal output
39 ~ 46
FI4 ~ FI7
SI4 ~ SI7
In Key input signal
47 ~ 50 In Not used.
51 FI10 In Button input signal input
52 SI10 In Not used
53 ~ 55 KI0 ~ KI2 In Button input signal input
56 MWNB Out Not used.
57 ~ 76 MA1 ~ MA17 Out Address bus
77 MCSB0 Out Chip enable signal output for the sound source ROM
78, 79 Out Not used
80 VCC In +5 V source
81 GND In Ground (0 V) source
82 MRDB Out Read enable signal output for the sound source ROM
83 ~ 98 MD0 ~ MD15 In/Out Data bus
99 PLE Out Latch enable signal output for LED latches
100 P17 In APO cancellation signal input