Filter
Top Products
E-18
2.
Use the TEMPO buttons to change the tuning of
the keyboard.
Example: To lower tuning by 20
❚
NOTE
• If you leave the tuning screen on the display for about five
seconds without doing anything, the screen is automatically
cleared.
• In step 2 of the above procedure, you could also use the number
buttons to input a value from 00 to 50.
• Pressing both of the TEMPO buttons ( / ) at the same time
returns the tuning setting to 00.
• Pressing the SONG BANK button changes the tuning setting
to 00.
• The tuning setting does not affect any of Song Bank tunes.
• You can tune the keyboard within a range of approximately
±50 cents (100 cents = 1 semitone).
• The tuning setting is automatically set to 00 whenever you turn
the keyboard on.
• Pressing the DEMO button changes the tuning setting to 00.
• The tuning operation does not affect rhythm (99 PERCUSSION).
Playing the demo tunes
You can set up the keyboard to continually play its 100 built-
in Song Bank tunes.
Keyboard keys light to indicate the melody notes of the demo
tune as it plays.
To start demo tune play
1.
Switch power on and adjust the volume level.
2.
Press the DEMO button.
• Demo tune play continues in a sequential endless loop
until you switch it off.
• The number and name of the demo tune currently
playing are shown on the display.
• You can play along on the keyboard while a demo
tune is playing back.
Tune
(
–
)
3.
You can change the demo tune play being played
by pressing the number buttons.
• The Song Bank tunes play back in tune number
sequence, starting from the one you select.
To stop demo tune play
Press the DEMO button or START/STOP button again to stop
demo tune play.
❚
NOTE
• Only the following buttons are enabled while a Song Bank tune
is being played.
• VOLUME buttons
• Number buttons
• START/STOP button
• POWER/MODE selector (OFF)
• DEMO button
• KEY LIGHT button
• VOICE button
• You cannot change the tone being used for the melody of a
Song Bank tune.
Playing rhythms
This keyboard features a collection of 50 exciting built-in
rhythm patterns. Each pattern provides percussion back up
for all your performances.
To select and play a rhythm
1.
Set the POWER/MODE selector to NORMAL.
2.
Find the rhythm you want to use in the “Rhythm
List” (page A-2) and note its rhythm number.
3.
Press the RHYTHM button.
• When you do, the RHYTHM indicator appears.
• The number and name that appear on the display
indicate the currently selected rhythm.
640A-E-020A
TEMPOSTART/STOP RHYTHM DEMO
POWER/MODE
Number buttons
LK43_e_15-21.p65 02.2.25, 9:48 PMPage 18 Adobe PageMaker 6.5J/PPC