Filter
Top Products
10
Turn off power and unplug units before connecting. (Please refer to TV’s Operation
manual)
Connecting to a TV
There are four connecting modes:(See the above figure)
1. Connect the composite video cable to the corresponding terminal of TV.
2. If the S-VIDEO terminal is available in your TV, you’re recommended to connect the S-VIDEO
output to the TV. Thus you can receive the better picture quality than mode 1.
3. If the video component outputs Y, Pb and Pr or Y, Cb and Cr are available in your TV, connect
the terminals to your TV, you can obtain the optimum quality of picture.If the Y,Cb, Cr input
terminals on your TV adopt progressive input mode, please press the VIDEO button on the
remote control to switch the unit to progressive output mode.
Notes:
• Please refer to the manual of the TV
• Turn off power and unplug both units before connecting.
• Connect the DVD player to your TV. If you connect this DVD player to camcorder or TV/VCR
combination, the playback picture will be distorted because the DVD player incorporate copyright
protection circuitry by Macrovision.
• Please consult the relative details about output of S-VIDEO and Y, Cb, Cr.
• When the DVD is connected with TV, please be sure to disconnect the other video output modes
when one of the terminals like composite video, S-video and component video (Y, Cb,Cr) are
connected so as to obtain the optimum picture quality.
S-Video
Component video input Pr/Cr
Component video input Pb/Cb
Component video input Y
Audio In
S-Video
Video In
Audio cable
S-Video Cable
Video Cable