Filter
Top Products
AUX Send Features
Six auxiliary sends are available for creating individual output mixes. These can be used to
drive effects processors, provide monitor mixes, create broadcast or alternate sound rein-
forcement mixes, or for other special requirements.
NOTE: The default PRE setting for the Auxes is pre-fader, but post-mute, post-insert, and
post-EQ. Internal settings can be changed so that PRE is also pre-EQ and pre-mute (See
Mono Input Channel NOTE).
Aux 1 - 2 PRE
AUX 1/2 stereo pair is post-fader.
AUX 1/2 stereo pair is pre-fader.
Aux Sends 1 & 2
Auxes 1 and 2 are permanently configured as a stereo pair. If the channel is configured
as a stereo input, the Left and Right signals are routed to Auxes 1 and 2, retaining the
stereo split. The PAN knob acts as a balance control. This stereo aux send can be used
for any type of stereo feed from the console, such as live two-track recording, stereo
in-ear monitors, alternate stereo feed for broadcast and stereo signal processors. Also,
by using the pan control to select a single bus, Auxes 1 and 2 can be used as discrete
mono Aux buses.
Aux 1/2 Level Sets level for the Aux 1/2 stereo pair.
Aux 1/2 PAN If the SUM INPUTS button is up, this knob controls the stereo balance
of the channel signal into Auxes 1 and 2. If the SUM INPUTS button is down, the
summed channel signal is panned between Auxes 1 and 2.
Aux Sends 3, 4, 5 & 6
Auxes 3, 4, 5, & 6 are configured as individual mono aux sends. They are typically used
to feed signal processors and on stage monitors. Stereo signals are summed together
to make up the source for Auxes 3, 4, 5 & 6.
AUX 3-4 PRE
AUX 3 and AUX 4 are post-fader.
AUX 3 and AUX 4 are pre-fader.
Auxes 3, 4, 5, & 6 Level Set Levels Auxes 3, 4, 5, & 6.
AUX 5-6 PRE
AUX 5 and AUX 6 are post-fader.
AUX 5 and AUX 6 are pre-fader.
p. 27
Stereo Input Channel
2