Filter
Top Products
Crestron C2N-RMAK Rack Mounting Kit
Rack Mounting Plate and Extension Brackets
Use the optional extension brackets to align the device ports with the ports of a
PRO2 control system or other device of equivalent depth.
Tools/hardware required
3/32” Hex key
8-32, 3/8” L Button cap screw (quantity eight, supplied)
Complete the following assembly procedure in the order provided (refer to
illustration below).
1. Holding the device facing you, position a bracket over the device’s
mounting holes as shown in the following diagram.
2. Thread the supplied screws from the front of the device through the
holes located on the extension bracket.
3. Using a hex key, tighten the screws to secure the extension bracket to
the device.
4. Repeat for the other bracket.
5. Position the rack mounting plate holes over the holes of the extension
bracket.
6. Thread the supplied screws from the front of the rack mounting plate
into the holes located on the extension bracket.
7. Using the hex key, tighten the screws to secure the extension bracket to
the rack mounting plate.
Assembly View
(SR08-32-0R3750-8)
SCREWS,
BUTTON HEAD
8-32X3/8"L
(SR08-32-0R3750-8)
BRACKETS
(MTBK02867-1)
PLATE
(MTPL02820-1SS1)
Installation Guide - DOC. 6131 Rack Mounting Kit: C2N-RMAK • 3