DOD VGS50 Musical Instrument User Manual


 
Note: The footswitches will only activate the user presets and banks. To access the
factory presets and banks, you will need to use the Data Wheel and scroll above the
last user bank/preset.
When you have selected a particular bank and preset, the number of the preset and
bank will be shown in the display. Each effect that is active in that preset will be
indicated by the lit LEDs above the effect select buttons.
Accessing the Tuner
The VGS50 includes a chromatic tuner to quickly get your instrument in tune. To
access the tuner, press and hold the footswitch that is currently active(the footswitch
with a lit LED above it). The letters “tu” will appear in the display. You can then
play any string on your guitar. The display (5) will show the note that you are
closest to, and the Tuner/Parameter LEDs (6) will light to let you know whether you
are sharp or flat. Your note is in tune when the green LED in the middle is lit. The
red and yellow LEDs above the green LED indicate that you are sharp and need to
tune down. The red and yellow LEDs below the green LED indicate that you are flat
and need to tune up.
The tuning reference on the VGS50 has been set to A=440 (concert pitch) from the
factory. You may change the tuning reference for drop tunings by rotating the Data
Wheel at any time while in the tuner mode. Your tuning choices are A (standard
tuning), Ab (1/2 step flat), and G (whole step flat).
Pressing any footswitch will exit the tuner mode and return you to the performance
mode.
Learn-a-Lick/Jam-a-Long
The Jam-a-Long feature lets you connect a tape or CD player to the VGS50 and
output the music into your amp with your guitar signal. The VGS50 also includes a
powerful teaching tool called “Learn-a-Lick”. This feature lets you record solos that
are too fast to hear much less learn, and then slow them down to a speed where
you can figure out what notes are being played. To use this feature you will need the
tape or CD with the “too-fast-solo” on it, a tape or CD player, and a cable with an
1/8” stereo jack on one end and a connector appropriate for your tape or CD
player’s headphone output on the other end.
Just follow these steps and you’ll have a virtual personal guitar instructor teaching
you all of those speed burning licks.
Page 7