Filter
Top Products
Now the only edit that we have left to do in our example is to assign the expression
pedal to control the reverb level. Piece of cake! Just press the Pedal button (12),
and rotate the Data Wheel until the number 9 is shown in the display. Since number
9 is Reverb Level, the expression pedal will now bring the amount of the reverb up
and down as you rock it back and forth.
With all of this accomplished, we will now need to store our new preset, otherwise
the VGS50 will forget the changes that we have made to this new preset.
Storing/Copying a Preset
Once you have edited a preset to your liking, you must store the preset in order for
the VGS50 to remember you settings. There are three steps to storing a preset.
1. Press the Store button (3) once. The Store LED will start flashing. The flashing
LED is basically asking “where do you want to store this sound”
2. Use the data wheel to select the user bank and preset number that you want to
save this new sound to.
3. Once you have selected the preset number that the new sound is to be save to,
press the store button again. The new sound will then be stored at the preset
number that you had selected.
Note: This same procedure can be used to copy a preset to a different preset
location.
To abort the store function, simply press any footswitch (1) and do not press the
store button a second time.
Page 12