Filter
Top Products
MIX 301 • Installation and Operation
Installation and Operation, cont’d
8
The blue connector does not have the extended tail or the
included tie-wrap.
Do not tin the power supply leads before installing in the
direct insertion connector. Tinned wires are not as
secure in the connectors and could be pulled out.
After making any adjustments to the MIX 301, either
via the front panel controls, SIS commands, or the
Extron Audio Products Control Program, wait at least
10 seconds after making those changes before
disconnecting power to the MIX 301. Failure to
observe the 10-second timeout may result in those
adjustments not being saved.
2
Power LED — Lights green to indicate that the MIX 301 has
power.
3
4
5
Balanced/unbalanced input connectors (IN 1, IN 2, IN 3) —
The balanced/unbalanced mono audio input is wired to a
3-pole, 3.5 mm captive screw connector. Wire the connector as
shown below.
Do not tin the connector leads before installing them in
the connector. Tinned wires are not as secure in the
connectors and could be pulled out. For further wiring
details, see the included “Cable Preparation For
Audio Connections” card.
Tip
Sleeve
Ring
Tip
Sleeve
Unbalanced Input
Left or Right
Balanced Input
6
Balanced output connector (MIX OUT) — The balanced mono
output is wired to a 3-pole, 3.5 mm captive screw connector.
Wire the connector as shown below for balanced or unbalanced
output devices.