N. POWER SWITCH - Switches the amplifier on-off.
O. IEC POWER SOCKET - Connect the power cord
(included) to a grounded AC receptacle in
compliance with the voltage and frequency ratings
specified on the rear panel of your amplifier.
P. TUNER - Connect your guitar tuner here. Use
MUTE {I} to silence audio output while tuning.
Q. LINE OUT - Balanced XLR jack for output to sound
reinforcement and recording equipment.
R. GROUND LIFT - Disconnects the LINE OUT {Q}
ground connection (pin-1) which may reduce hum
noise in some situations.
GROUNDED (normal) GROUND LIFTED
S. PRE/POST EQ - Supplies the LINE OUT jack with
the signal either before or after it is processed by the
amplifier’s tone and equalization circuits.
PRE (tone/EQ bypassed)
POST (tone/EQ active)
T. LINE OUT LEVEL - Adjusts the signal output level
of the LINE OUT jack {Q}.
U. FOOTSWITCH - Connect the included footswitch to
enable remote on-off switching of REVERB,
TUNER MUTE and the EFFECTS LOOP.
NOTE:
When connected, the footswitch buttons over
ride
the corresponding controls on the front panel.
V. FX SEND / FX RETURN - (1) Effects Loop -
Connect FX SEND to your effects input and effects
output to FX RETURN. (2) Multiple Amps - Connect
FX SEND on the primary unit to FX RETURN on the
auxiliary unit. The primary unit controls all auxiliary
units.
7
S
S
SS
p
p
pp
e
e
ee
c
c
cc
i
i
ii
f
f
ff
i
i
ii
c
c
cc
a
a
aa
t
t
tt
i
i
ii
o
o
oo
n
n
nn
s
s
ss
TYPE: PR 411
PART NUMBERS: 2289500000 (120V, 60Hz) USA 2289503000 (240V, 50Hz) AUS 2289504000 (230V, 50Hz) UK
2289506000 (230V, 50Hz) EUR 2289507000 (100V, 50Hz) JPN
POWER REQUIREMENT: 540W
PREAMP INPUT IMPEDANCE: NORMAL: 1MΩ –10dB PAD: 1MΩ
SENSITIVITY AT FULL POWER: NORMAL: 19mV –10dB PAD: 40mV
NOMINAL LEVEL: NORMAL: 145mV –10dB PAD: 300mV
POWER AMP SENSITIVITY
:
1.4V R.M.S., 1kHz
POWER OUTPUT
:
200W R.M.S. into 4
Ω @ < 0.1% T.H.D., 1 kHz
TONE CONTROLS EQ TILT: ±10dB, crossover frequency: 350Hz
BASS/TREBLE: BASS: ± 15dB @ 50Hz TREBLE: ± 15dB @ 10kHz
SEMI-PARAMETRIC MID: MID FREQ: 200Hz to 1.0kHz MID LEVEL: ±15dB @ MID FREQ setting
EFFECTS LOOP IMPEDANCES: SEND: 1kΩ RETURN: 11kΩ
NOMINAL LEVEL: +4dBu (adjustable with level contr
ol)
FOOTSWITCH: Three button, included: Reverb, Tuner Mute, Effects Loop (064544)
SPEAKER: One 15", 4
Ω
Fender
®
Custom 15 Driver
, made in USA by Eminence
®
(064398)
FITTED COVER: Included (065532)
DIMENSIONS: HEIGHT
:
21 in (53.3 cm) WIDTH: 20 in (50.8 cm) DEPTH: 12.5 in (31.8 cm)
WEIGHT: 65 lb (29.5 kg)
Pr
oduct specifications ar
e subject to change without notice.
R
R
RR
e
e
ee
a
a
aa
r
r
rr
P
P
PP
a
a
aa
n
n
nn
e
e
ee
l
l
ll
✧
w
w
w
w
w
w
.
.
f
f
e
e
n
n
d
d
e
e
r
r
.
.
c
c
o
o
m
m
✧