Filter
Top Products
Use the face panel located rotary CUE VOLUME CONTROL
(13) to adjust the CUE volume without changing the overall mix.
By turning the face panel located CUE 1/2 ROTARY CONTROL
(14) counter clockwise you will be able to choose the channel
you wish to monitor.
5. CROSS FADER SECTION: The CROSS FADER (16) allows
you to mix from one source to another. The CROSS FADER (16)
in your unit is removable and if the need arises can be easily
replaced. Also available are our RG-45 (RAIL GLIDE™) DUAL-
RAIL CROSS FADER and RG-45Pro (Rail Glide PRO) The
RG-45 features, a stiffer feel and smoother curve specially made
for mixing, while the RG-45Pro is specially designed for scratch-
ing, with a smoother feel and a special scratch-oriented curve.
Just purchase one from your Gemini dealer and follow the
instructions:
N
OTE: DO NOT APPLY PRESSURE WHILE USING THE CROSS FADER (16).
LIGHTLY GLIDE THE CROSSFADER BACK AND FORTH. PRESSING DOWN
O
N THE CONTROLS CAN BEND CONTACTS AND CAUSE A LOSS OF
SOUND.
6. OUTPUT SELECTION CONTROL: Once you are comfort-
able with the sound level of your music you may adjust the vol-
ume with the MASTER (11) rotary control.
7. MIC SECTION: Plug your main MIC into the MIC 1/4" input
(3) located on the rear panel.
8.”Ipod Friendly” cable:To connect your Ipod or other Digital
Media Player, use the included Ipod cable. Connect the 1/8’’ end
of the cable to the headphone or line out jack of your player, and
connect the RCA end to the line input (7) of your mixer.
INPUTS:
Phono..................................................................3 mV, 47 KOhm
Line.................................................................150 mV, 27 KOhm
MIC…………..........……….................1.5 mV, 1 KOhm Balanced
OUTPUTS:
Max.................................................................20V Peak-to-Peak
GENERAL:
Frequency Response................................20Hz - 20KHz +/- 2 dB
Distortion.........................................................................< 0.02%
S/N Ratio.........................................................Better Than 80 dB
Headphone Impedance...................................................16 Ohm
Power Source.....................................AC 15V 500mA
Dimensiones....................................................6.5" x 3.3" x 10"
…………………………………………….....(165 x 84 x 254 mm)
Weight...........................................................3.3 lbs (1.5kg)
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTIFICATION FOR
I
MPROVEMENT.
SPECIFICATIONS:
REPLACEABLE CROSS FADER
1
. UNSCREW THE OUTSIDE FACE PLATE SCREWS ON THE LOWER HALF OF
THE MIXER. REMOVE THE FADER CAPS AND FACE PLATE.
2.UNSCREW THE FADER (B)
SCREWS. DO NOT TOUCH INSIDE
S
CREWS (C). CAREFULLY
REMOVE OLD CROSS FADER AND
UNPLUG CABLE (D).
3. PLUG IN THE NEW CROSS
FADER INTO CABLE (D) AND
P
LACE BACK INTO MIXER.
4. SCREW THE CROSS FADER TO
M
IXER WITH THE FADER PLATE
SCREWS (B).
5. REPLACE THE LOWER HALF
F
ACE PLATE AND SCREW TO THE
MIXER.