Filter
Top Products
H8069 Heirloom Stratocaster-Style Guitar Kit
-19-
String Retainers
The string retainers mount between the 1st and
2nd strings and between the 3rd and 4th strings
(Figure 33). String retainers are designed to hold
the strings down against the nut to enable correct
tuning.
Components and Hardware Needed: Qty
Neck and Body (Assembled) .............................
1
String Retainers ................................................. 2
Bushings 4 x 5 x 3mm .......................................
2
Chrome Screws 2.5 x 14mm ............................. 2
Figure 33. String retainer locations.
2nd Retainer
1st Retainer
To install the string retainer:
1. Place the 1st string retainer on top of the 1st
and 2nd strings near the second tuner and
loosen the strings several turns.
2. Using a
1
⁄16" drill bit positioned through the
string retainer, drill a
1
⁄4" deep hole into the
headstock.
Note: Drilling the hole deeper than
1
⁄2" could
result in drilling out the bottom of the head
-
stock.
3. Slide a 2.5 x 14mm screw through the retainer
and bushing, then fasten it to the headstock
(Figure 33).
4. Place the 2nd string retainer on top of the
3rd and 4th strings, loosen the strings, and
repeat Steps 2–3.