Filter
Top Products
-6-
H3098 Western Guitar Kit
Like the guitar body, most of the guitar neck has
been machined at the factory; however, the neck
headstock can be customized to reflect personal
taste. Additional cutting, inlay, or design work can
give an otherwise ordinary guitar that custom look
that sets it apart from others! Note—Take your
time with this sub-section and consider testing
ideas in scrap wood before performing the work
on the actual headstock.
To sand the guitar neck:
1. Wear an ANSI-approved respirator and
safety glasses when sanding wood!
2. Perform any custom cutting, inlay, or design
work to the neck headstock.
3. Using the sanding technique described in the
previous sub-section, sand the entire guitar
neck, EXCEPT for the fingerboard mounting
surface. Note—Sanding the fingerboard
mounting surface will affect the playability of
the guitar and could lead to unrepairable
damage.
The fingerboard requires no sanding. Note—
Sanding the fingerboard will affect the playability
of the guitar and could lead to unrepairable dam-
age.
The bridge is rough sanded at the factory. Final
sand the bridge as described in the Guitar Body
sub-section.
Bridge
FingerboardNeck