Filter
Top Products
-12-
H3122 Classical Guitar Kit
To attach the sound hole decal:
1. Submerge the decal sheet in water until the
clear decal slides around on the paper back
-
ing easily with finger pressure. This usually
only takes a few minutes.
2. Remove the decal sheet from the water, let-
ting the excess water run off.
3. Lay the decal sheet over the sound hole.
4. Lightly press down on the decal with damp-
ened fingers and slowly slide the decal sheet
from underneath the decal with the other
hand.
5. When the decal sheet is completely removed,
lightly press on the decal with a dry cloth to
remove the excess water trapped under
-
neath.
To attach the bridge to the body:
1. Remove the masking tape from the bridge
location.
2. Apply a thin, even layer of wood glue to the
back of the bridge.
3. Position the bridge on the bridge location
penciled on the body.
4. Make sure the bridge is correctly positioned
and let it dry for at least 6 hours
.
5. Using a
1
⁄8" drill bit, drill out the two mounting
holes in the bridge.
6. Secure the bridge to the body with the sup-
plied screws, washers, and nuts.
7. The heads of the screws can be covered with
the bridge decoration sticker.
Attaching Bridge
Sound Hole Decal